ZK10UF ZK30UF Tablets Tungsten Carbide Wear Parts in Well Drilling
There has been a rapid development in well drilling tools, with
improved performance which has led to the increasing substitution
of steel tools by cemented carbide tools, in particular in the oil
industry. Notably, the use of very coarse grained hardmetals is
growing in this application area.
Tungsten carbide tablets are widely used as wear parts in a lot of
industry due to its excellent performance. Tungsten carbide is
facing with the resistant-wearing, high fracture strength, high
thermal conductivity, small heat expansion co-efficient. So some
spare parts takes the tungsten carbide to enhance the service life.
As we know, the sledbase are frequently used in the snow. It is too
expensive to change the whole fracture. So if the specific part is
replaced by the tungsten carbide, the service life of the sledbase
is improving and prolonging. Our factory can produce the specific
chape of tungsten carbide strips to meet the different shape of the
sledbase. Once the below parts of the sledbase is damaged, we can
just replace the small parts of the sled.
At the meantime, our factory can not only produce the specific part
in the sledbase, but also weld it for you if you ask and require.
Cemented cabide grades for Snow Blade
Good hardness and normal strength, for drawing of steel and
and alloy bars or tubes under the condition of higher Stress.
High wear resistance and high hardness,for drawing of steel wires
and non-ferrous metal wires
or alloy bars under low-stress condition.
High wear resistance and high hardness,for drawing and
straightening steels,non-ferrous metal
and alloy bars and tubes; And for fabricating of machine
parts,tools and wear parts,
such as nozzles,centres,guiding devices,upsetting dies and
Good strength and impact toughness; suitable for
plates,bars,saws,seal rings,tubes etc. And it is
one of the most popular grade for wear parts.
High Strength and impact toughness, but lower hardness and wear
resistance.For drawing steel
rools and pipes under high stress condition;And also for upsetting
dies and perforating tools
under higher impact loading.
Used as wear parts,sheets and some mechanical components.
Fine-grained alloy, good wear resistance and high strength.It is
one of the most popular grade
for rods,bars,tubes and other wear parts, which need high wear
resistance and good cautery
resistance and low impact toughness.
Fine grain grade. Excellent wear resistance, high in strength and
impact resistance. Suitable for
rough machining of cast iron,non-ferrous metals,nonmetallic
materials and heavy cutting.